TEST ACTION APPLICABILITY
3 Turn the ignition off.
Disconnect the Driver Window Motor connector.
Disconnect the BCM C2 harness connector.
Measure the resistance between ground and the Driver Window Up Driver circuit.
Is the resistance below 1000.0 ohms?
All
Yes → Repair the Driver Window Up Driver circuit for a short to ground.
Perform BODY VERIFICATION TEST - VER 1.
No → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
348
POWER WINDOWS
DRIVER WINDOW UP OUTPUT SHORT TO GROUND — Continued
To Next Page
Loading...
