Dodge ZB 2005 - Page 1747

TEST ACTION APPLICABILITY
4 Gain access to and disconnect the Driver Power Window Motor connector
Using a 12-volt test lightconnected to ground,check the Driver Window Down Driver
circuit.
With the DRBIIIt, actuate the DRV WINDOW DN..
Does the test light illuminate brightly when the DRV WINDOW DN circuit is
actuated?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Go To 5
5 Gain access to and disconnect the Driver Power Window Motor connector
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Driver Window Down Driver circuit between the BCM
C2 connector and the Window Motor connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Driver Window Down Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
6 Gain access to and disconnect the Driver Power Window Motor connector
Disconnect the Body Control Module C2 connector.
Measure the resistance of the Driver Window Up Driver circuit between the BCM C2
connector and the Window Motor connector.
Is the resistance below 5.0 ohms?
All
Yes → Replace the Body Control Module.
Perform BODY VERIFICATION TEST - VER 1.
No → Repair the Driver Window Up Driver circuit for an open.
Perform BODY VERIFICATION TEST - VER 1.
366
POWER WINDOWS
*DRIVER WINDOW INOPERATIVE — Continued