(3) Install cotter pin through nut and stud of
upper ball joint (Fig. 43).
(4) Install ABS wheel speed sensor in steering
knuckle (Fig. 42). Install and tighten mounting bolt
to 11 N·m (100 in. lbs.) torque.
(5) Install brake rotor and brake caliper on
knuckle. (Refer to 5 - BRAKES/HYDRAULIC/ME-
CHANICAL/ROTOR - INSTALLATION)
(6) Install wheel and tire assembly (Refer to 22 -
TIRES/WHEELS - INSTALLATION). Progressively
tighten wheel mounting nuts in proper sequence to
122 N·m (90 ft. lbs.) torque.
(7) Lower vehicle.
(8) Position vehicle on alignment rack/drive-on
hoist.
(9) Set vehicle to design height. (Refer to 2 - SUS-
PENSION/WHEEL ALIGNMENT - STANDARD
PROCEDURE - DESIGN HEIGHT MEASURE-
MENT)
(10) Tighten upper control arm frame mounting
bolts to 102 N·m (75 ft. lbs.) torque.
(11) Perform wheel alignment. (Refer to 2 - SUS-
PENSION/WHEEL ALIGNMENT - STANDARD
PROCEDURE)
(12) Road test vehicle to ensure proper operation.
ZB FRONT SUSPENSION 2 - 27
UPPER CONTROL ARM (Continued)
To Next Page
Loading...
