Dodge ZB 2005 - Page 89

CONDITION POSSIBLE CAUSES CORRECTION
3. Broken Or Weak Coil Spring(s). 3. Replace Coil Spring(s).
4. Shock Absorber Not Functioning
Correctly
4. Replace Shock Absorber.
. 5. Excessive Friction In Steering
Gear.
5. Replace Steering Gear.
6. Excessive Friction In Steering
Column Shaft Coupling.
6. Replace Intermediate Steering Shaft.
7. Loose Or Worn Upper Or Lower
Control Arm Isolator Bushings.
7. Inspect Control Arm Bushings For Wear
Or Looseness And Replace As Required.
8. Incorrect Front Or Rear Wheel
Alignment.
8. Verify Vehicle Alignment And Adjust To
Preferred Specifications As Required.
EXCESSIVE FORCE
REQUIRED TO STEER
VEHICLE
1. Low Or Uneven Tire Air Pres-
sure.
1. Inflate All Tires To The Recommended
Pressure.
2. Loose, Worn Or Glazed Power
Steering Pump Drive Belt.
2. Tighten Or Replace The Power Steering
Pump Drive Belt As Required.
3. Low Fluid Level In Power Steer-
ing System.
3. Fill The Power Steering System To The
Required Fluid Level.
4. Lack Of Assist From Power
Steering Pump.
4. Test Power Steering Pump And Replace
If Required.
5. Upper Or Lower Ball Joints
Require Lubrication.
5. Properly Lubricate Ball Joints Or
Replace If Required.
6. Tie Rod Ends Require Lubrica-
tion.
6. Properly Lubricate Tie Rod Ends Or
Replace If Required
7. Steering Gear Malfunction. .7. Replace Steering Gear.
8. Incorrect Front Wheel Alignment
(Particularly Caster).
8. Verify Vehicle Alignment And Adjust To
Preferred Specifications As Required.
VEHICLE PULLS TO ONE
SIDE
1. Low Or Uneven Tire Air Pres-
sure.
1. Inflate All Tires To The Recommended
Pressure.
2. Radial Tire Lead (See Tire Ser-
vice).
2. Inspect Tires For A Condition Of Radial
Tire Lead And Replace Tires As Required.
3. Brake Caliper Hanging Up. 3. Diagnose Vehicle For Condition Of
Brake Pull And Correct As Required.
4. Broken Or Weak Rear Spring. 4. Replace Rear Coil Spring.
5. Loose Or Worn Suspension
Component Bushings.
5. Inspect The Suspension Components
For Worn Or Lose Bushings And Replace
The Bushing Or Component As Required.
6. Incorrect Front Wheel Alignment
(Either Caster Or Camber).
6. Verify Vehicle Alignment And Adjust To
Preferred Specifications As Required.
2 - 60 WHEEL ALIGNMENT ZB
WHEEL ALIGNMENT (Continued)