An electronic GUARD Slimline Compact is presented in the following
section. The procedure for other electronic handles is the same as the
one described here.
It is possible to damage the surface of the lever handle when
removing the cover.
Do not use any force when removing covers from handles.
Twist the cover round the lever handle while pulling it off in
order to avoid contact.
Damage to the electronic components of the handle due to
contact possible.
Do not touch the electronic components of the handle.
Touch an earthed object made of metal to discharge any
electrostatic charge before continuing work.
A heater or tap are examples of suitable earthed objects.
You will require a Torx10 screwdriver to release the screw on the cover
closure.
Proceed as follows to remove the cover from the electronic handle:
To Next Page
Loading...