If you are using handles which read on both sides, you must ensure that the
spindle is of the correct length as described from page 64 onwards.
The standard spindle has 9 mm edge length. Adapter sleeves in three sizes
are available for spindle hubs with a smaller edge length. With these adapter
sleeves you adapt the supplied spindle with smaller edge length to the
dimensions of the inside lever handle and the coupling nut of the electronic
handle side.
If you are using a standard spindle, you can fit this as described from page 64
onwards.
If a lock which is present necessitates a different edge length, you must use
adapter sleeves to adapt the spindle on the spindle hub or coupling nut and
inner lever handle. A suitable spindle and adapter sleeves in line with the
dimensions which you stated when placing the order are included in the scope
of delivery.
Adapter sleeves in three sizes are available for a spindle hub with a smaller
edge length. With these adapter sleeves you adapt the supplied spindle with
smaller edge length to the dimensions of the inside lever handle and the
coupling nut.
• Adapter sleeves for spindle with edge length 7 mm
• Adapter sleeves for spindle with edge length 8 mm
• Adapter sleeves for spindle with edge length 8.5 mm
An adapter sleeve for the lock can be supplied for a spindle hub with 10 mm
edge length. With this adapter sleeve you adapt the measurement of the
spindle hub to the standard spindle 9 mm.
• Adapter sleeve for spindle with edge length 10 mm
The procedure for attaching the adapter sleeves differs in line with the desired
dimensions.
The procedure for attaching the adapter sleeves is described in the sections
from page 66 onwards.
To Next Page
Loading...