The assembly of the handles varies for the different versions. You should in
principle proceed as follows for assembly:
• Check all parts for completeness and flawless condition.
• Make sure that the tool required and additional material are in place.
• Prepare the door for assembly.
• Align the lever handle on the outside as desired and install it on the handle.
• Install the spindle and if necessary the adapter sleeve(s) in the handle for
the outside.
• Install the handle on the outside of the door.
• Align the lever handle to the inside as desired and place it on the spindle.
• Install the handle on the inside against the handle on the outside of the
door.
• Test the handle for flawless functioning.
Danger of injury to the fingers or hands on edges of the
installation profile or the lock.
Wear suitable safety gloves.
Risk of finger or hand injuries caused by slipping during
drilling or screwing work.
Wear suitable safety gloves.
Observe and follow the notices provided in the drilling
machine documentation when drilling.
Remove the handle from the original packaging.
Keep the original packaging for later use.
The original packaging will be necessary for storage at a later date or sending
after use.
The scope of supply depends on the properties of the handle which was
ordered, the door and the lock which were stated in your order.
Check whether all components of the handle were supplied.
Check whether all accessories ordered were supplied.
Check all parts supplied for flawless condition.
To Next Page
Loading...