Check the following points in particular:
• Does the spindle which was supplied have the correct dimensions for the
lock and the door?
• Were the correct adapter sleeves supplied (type and dimensions)?
If parts are missing, damaged or supplied with incorrect measurements,
contact the appropriate specialist retailer or the manufacturer.
Ensure that the door is correctly attached.
Ensure that the door is not warped.
Ensure that the door is not under strain.
Ensure that the door’s construction type makes installation of the handle
possible.
Ensure that the door has appropriate drill holes for attachment of the handle
in line with the applicable standards where necessary.
Check the following points in particular:
• Are the holes at the attachment points present and sufficiently large?
• Have chippings which developed during drilling been removed properly?
• Was the hole in the lock calibrated properly with the hole in the door?
Make sure that all these points have been fulfilled, by carrying out extra
work if necessary.
Make sure that the tool required and material are in place.
You will require the following tools:
• Allen key, 2 mm for horizontal alignment of the lever handle and for fixing
the spindle in the coupling module
• TORX10 screwdriver, not angled, for removing the cover from the digital
handle
• TORX25 screwdriver for screwing the lever handle and halves of the handle
• Rosette lifter for lifting the covers of the mechanical handle
• Assembly tool for installing in round rosette screwing points if necessary
• Clamping device and metal saw for shortening the spindle if necessary
You will require the following material for lifting mechanical covers or covers
for rosettes:
• Protective cover for door (cardboard or film) for levering on the door with the
rosette lifter
The tool and the material are not included in the scope of supply.
To Next Page
Loading...