Following use
Removing handle
The removal of the handles is in principle in the reverse order to the assembly.
Proceed as follows:
• Remove the cover and/or rosettes on the inside of the door.
• Check whether you can loosen all screw connections.
• Remove the cover and/or rosettes on the outside of the door if necessary.
Make sure that the tool required and material are in place.
You will require the following tools:
• TORX10 screwdriver, not angled, for removing the cover from the digital
handle
• TORX25 screwdriver for screwing the lever handle and halves of the handle
• Rosette lifter for lifting the covers of the mechanical handle
• Long nose pliers for removing adapter sleeves
You will require the following material for lifting mechanical covers or covers
for rosettes:
• Protective cover for door (cardboard or film) for levering on the door with the
rosette lifter
The tool and the material are not included in the scope of supply.
Remove mechanical cover and rosettes
Damage to the door is possible when opening with a rosette
lifter.
Do not use any force when opening the covers for
mechanical handles.
Cover the door prior to removing the cover.
You can use a stable film or cardboard to cover the door for example.
It is possible to damage the surface of the lever handle when
removing the cover.
Do not use any force when removing covers from handles.
Twist the cover round the lever handle while pulling it off in
order to avoid contact.
To Next Page
Loading...