GUARD Compact Wideline set reading on one side
The short plate with reading field is attached on the outside of the door. Two
catch sleeves are inserted laterally on the outer assembly profile for this
purpose. The inner assembly profile is attached with two long screws which
are screwed into these catch sleeves.
The outer cylinder rosette is attached with two head sleeves on both sides of
the cylinder. The inner cylinder rosette is screwed in the head sleeves with two
long screws.
Attachment by screwing on is not possible for this handle.
Always install the lever handle fittings/rosettes first for two-part handles. Only
install the cylinder rosettes once the lever handle fittings/rosettes have been
installed.
You must attach the spindle and lever handle to the handle prior to attaching
the handle in position.
The attachment of the lever handle to the electronic handle is described
from page
60 onwards.
attachment of the spindle is described from page 63 onwards.
The attachment of the spindle with reducing bushes is described from
page 66 onwards.
It is possible to damage the surface of the lever handle when
removing the cover.
Do not use any force when removing covers from handles.
Twist the cover round the lever handle while pulling it off in
order to avoid contact.
To Next Page
Loading...