Insert the spindle in the electronic assembly profile (1) on the outside into
the spindle hub.
Press the assembly profile on the door leaf until it comes to a stop.
Insert two suitable short screws (3) into the centre and lower drill hole (2).
Tighten the centre short screw so it is hand tight.
Tighten the lower short screw so it is hand tight.
Check the lever handle for ease of movement.
Release the centre short screw a little if the lever handle does not move
easily.
Check the lever handle for ease of movement once again.
Remove the other cover on the assembly profile in the same way.
Fit the assembly profile on the inside in the same way.
It is possible to damage the surface of the lever handle when
fitting the cover.
Do not use any force when installing the covers of handles.
Twist the cover round the lever handle while fitting in order
to avoid contact.
Ensure that the cover and the lever handle do not touch
when fitting the cover.
To Next Page
Loading...