5. Open the sda1 or sdb1 folder.
1.Notes "sda1" and "sdb1" are the top level partitions of USB memory devices that
are connected to the controller.
2. "sda1" is the first USB memory device that was connected. "sdb1" is the
second USB memory device that was connected.
6.
Open the folder that contains the label file.
7.
Select the tick box next to the label to be imported.
8.
Select the Copy or Move icon.
9. On the right side of the screen, navigate to and open the controller's Label folder.
10.
Select the Move/Paste icon.
11. Remove the USB memory device from the controller.
End of procedure.
Export Label
To export a label from the printer to a USB memory device:
1. Insert the USB memory device into a USB port on the controller.
Note Note: FAT32
2. Wait until the USB icon on the information bar turns green.
3.
Select Home > Setup > File Manager.
4.
Open the controller's Label folder.
5.
Select the tick box next to the label to be exported.
OPERATION
169 EPT053091 - Issue 5 - 07 May 2021
To Next Page
Loading...