PART 2 INSTALLATION
UNPACKING
Remove the controller, print heads and accessories (e.g. encoder and sensor) from the
packaging.
The equipment delivered will vary according to the specific order. Check the contents of the
shipment against the packing list and report any dierences to Domino.
CONTROLLER AND PRINT HEAD LOCATION
Position the controller and print heads:
• Where they are electrically isolated from other equipment.
• Where the temperature remains within the specified range, see Environment on page 19.
•
Where the relative humidity remains within the specified range, see Environment on page
19.
• Close to an accessible power outlet, to ensure power can be disconnected quickly.
INSTALLATION
EPT053091 - Issue 5 - 07 May 2021 22
To Next Page
Loading...