Dormakaba c-lever pro - 8.6.2 Reset Using Tweezers

Service Technical Manual
62 HAC Standard fixing - 02/2018dormakaba c-lever pro
8.6.2 Reset using tweezers
NOTICE
Danger of damage to electronic components from electrostatic discharge.
If electronic printed circuit boards and components are handled incorrectly, damage may oc-
cur which leads to their complete breakdown or sporadic faults.
• When installing and repairing the product, the general ESD protective measures are to be
observed.
Requirements
• The multitool is available
• Electrically conductive tweezers are available.
• The batteries are inserted
Procedure
NOTICE
Damage to the union nut
When loosening the union nut, make sure it does not touch the threaded pin.
• Using the multitool, loosen the union nut from the internal fitting (>360°).
>360°
• With locking cylinder: If necessary, loosen the forend locking stud.
• Push the cover out of the groove (1), pull it forwards slightly (2) and turn (3).