152 Instructions for use | Atlan A300, A300 XL, A350, A350 XL SW 1.0n
Alarms
10 Alarms
10.1 Safety instructions
Alarm volume
If the alarm volume is too low, alarm signals may not be heard. The patient may be
put at risk.
► Set the alarm volume loud enough so that the alarm signals can be heard in the
environment where the device is located.
► The user must remain within earshot of the alarm signals.
Recognizing alarm signals
If alarm signals are not noticed, the patient may be put at risk.
► Dräger recommends that the user remains in the vicinity of the anesthesia
machine, i.e. within a distance of up to 4 meters (12 feet). This facilitates fast
recognition and response in the event of an alarm.
► If the causes of the alarm are only temporary, the alarms will likewise only be
indicated temporarily.
Impaired Infinity ID functions
Electromagnetic disturbances or faults in Infinity ID components can cause
permanent alarms.
► Contact service personnel to deactivate the Infinity ID alarms.
10.2 Displaying alarms
Alarms are signaled optically and acoustically during the therapy. In standby mode,
alarms are signaled optically. However, if the user must respond to certain alarms in
standby mode, these alarms will also be signaled acoustically.
To Next Page
Loading...
Need help?
General
