Dräger Atlan A350 - Page 243

Instructions for use | Atlan A300, A300 XL, A350, A350 XL SW 1.0n 243
Reprocessing
After complete disassembly of the breathing system, the following machine-
reprocessable components are present:
– Upper part of the breathing system
– Lower part of the breathing system
– Sensor cap of the O
2 sensor
–APL valve
– Inspiratory port
– Expiratory port
– Inspiratory valve (yellow)
– Expiratory valve (blue)
– Fresh-gas decoupling valve (black)
– Piston diaphragm
– Breathing bag arm (option)
Optionally present are:
– Absorber container and absorber insert
– CLIC adapter (option)
Required aids:
– Hose for connecting the breathing bag arm
– Hose for connecting the absorber insert
13.10.2 Positioning the components
Depending on device configuration, it is possible that not all components will be
present.
► Position the components securely in the load carrier. Ensure the following:
– All surfaces and interior spaces can be flushed completely.
– The water can drain off freely.
The following illustrations are nonbinding recommendations. Depending on the
washer-disinfector used, alternative positioning is possible.