DRAGFLOW S.r.l. - Sede legale: Via Satiro, 11 – 37121 VERONA Italy
Sede amm.: Via Paesa – 46048 ROVERBELLA (MN) Italy ● Tel. +39 0376 1685400
Fax +39 0376 1685499 - Cod. Fisc e P. IVA : IT 02757460239 – R.E.A. Verona n. 280092
Registro Impr. Di Verona n. 189595/1997 Capitale Sociale € 10.400 interamente versato
EL7.5 - EL12.5 (S - SS) User manual - ENG 26/70
- placing the machine in a stable position out of the water, start it for a short
time (not more than 10 seconds) and check the correct rotation comparing it
with the red arrow printed on the plate (see Fig. 7) and eventually switch two
phases of the power cable on the control panel terminal board;
Fig. 7
Before switching the phases into the control
box, make absolutely sure that this is shut
down and without the voltage.
- take care of any noise or vibration that could mean some unforeseen
anomalous condition of the machine.
During the first starting, inform immediately
the manufacturer Service Department about
any anomaly.
To Next Page
Loading...