Use the drop down menu to choose a proper WAN interface
for this profile. This setting is useful for dial-out only.
Or,
WAN1 First/ WAN2 First /WAN3 First (or LTE First) /WAN4
First- While connecting, the router will use
WAN1/WAN2/WAN3(or LTE) /WAN4 as the first channel for
VPN connection. If WAN1/WAN2/WAN3 (or LTE) /WAN4 fails,
the router will use another WAN interface instead.
WAN1 Only /WAN2 Only/WAN3 Only(or LTE Only) /WAN4
Only - While connecting, the router will use
WAN1/WAN2/WAN3(or LTE)/WAN4 as the only channel for
VPN connection.
WAN1 Only: Only establish VPN if WAN2 down - If WAN2
failed, the router will use WAN1 for VPN connection.
WAN2 Only: Only establish VPN if WAN1 down - If WAN1
failed, the router will use WAN2 for VPN connection.
Always On Check to enable router always keep VPN connection.
Server IP/Host Name
for VPN
Type the IP address of the server or type the host name for
such VPN profile.
IKE Authentication
Method
IKE Authentication Method usually applies to those are
remote dial-in user or node (LAN to LAN) which uses dynamic
IP address and IPsec-related VPN connections such as L2TP
over IPsec and IPsec tunnel.
Pre-Shared Key- Specify a key for IKE authentication.
Confirm Pre-Shared Key-Confirm the pre-shared key.
Digital Signature
(X.509)
Click Digital Signature to invoke this function.
Peer ID – Choose the peer ID selection from the drop down
list.
To Next Page
Loading...
Need help?
General
