Draytek Vigor2926L - Page 807

Vigor2926 Series User’s Guide
791
1=auto
2=manual(traffic)
3=manual(qos)
4=manual(specific hosts)
0=disable
-p <proto> Specify a protocol.
proto - 1-TCP; 2-UDP; 3-Both.
-b 1/0 Enable/disable TWO-way hardware acceleration.
-M enable/disable Enable/disable the multicast hardware acceleration.
-v Show PPA_WAN_Table and PPA_LAN_Table for reference.
-c Clean all settings.
ppa n – used in QoS or specific host
-l <rule> Specify an index number of rule profile for QoS mode.
-h <host> Type an IP address for Specific Host mode.
-s <start port> Specify a starting port number for Specific Host mode.
-e <end port> Specify an ending port number for Specific Host mode
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> ppa -m 1 -p 1 -b 0
Set ok! The PPA mode is Auto
% You need to set the Manual mode first !
%TWO way accleration is disable
> ppa -v
% PPA mode is Auto
%PPA Protocol TCP 1, UDP 0
%PPA two way disable
%PPA time is 10
%PPA range is 192
%PPA LAN entries 0
%PPA WAN entries 0
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
p
p
r
r
n
n
This command allows you to view current status (interface and driver) of USB printer.
S
S
y
y
n
n
t
t
a
a
x
x
prn status
prn debug
E
E
x
x
a
a
m
m
p
p
l
l
e
e
> prn status
Interface: USB bus 2.0
Printer: NotReady
> prn debug
conn[0] :