profiles will be activated alternatively.
Recover – Indicate the duration of VPN backup operation.
Resume – When VPN connection breaks down or disconnects,
Member 1 will be the top priority for the system to do VPN
connection.
Second – “0” means to dial each six seconds automatically. “60 ~
2147483647” means to early handle for less than 30 seconds within
designated time.
lb <add/del> <name>
<Member#1> <Member#2>
It means to create VPN trunk with load balance.
add/del - Add or delete a profile for used in VPN Trunk.
name – Specify the name of the VPN trunk.
Member#1 – Indicate the first LAN to LAN profile.
Member#2 – Indicate the second LAN to LAN profile.
lb algorithm <name>
<RR/W-RR/Fastest>
Set multiple VPN tunnels for using as traffic load balance tunnel.
Such command is to configure the algorithm (with round robin
mode) of Load Balance.
name – Specify the name of the VPN trunk.
RR – It means round robin mode. All of the dial-out profiles will be
taken turns equally.
lb algorithm
<AccordingRatio>
<Member1:Member2>
Such command is to configure the algorithm (with round robin
mode) of Load Balance.
name – Specify the name of the VPN trunk.
W-RR – It means weighted round robin mod based on speed ratio.
Auto - the speed must be based on Lay2.
AccordingRatio – the speed must be based on given ratio.
Member#1 – Inidcate the first LAN to LAN profile.
Member#2 – Indicate the second LAN to LAN proifle.
lb algorithm
<name><Fastest>
Such command is to configure the algorithm (with fastest mode) of
Load Balance. Most of traffics will be led to the channel with the
fastest connection.
name – Specify the name of the VPN trunk.
bind usage <BindIndex> Display detailed information for VPN Load Balance Tunnel Bind.
BindIndex – Indicate the index number of the tunnle bind.
bind show
<LoadBalanceName>
Display the bind information for VPN Load Balance profile.
LoadBalanceName – type the name of VPN Load Balance profile
bind reset_default Reset the bind tunnel for VPN load balance to factory reset settings.
bind set <BindIndex> <ACT>
<TrunkName> <Member>
<SrcIp:A~B> <DstI p:A~B>
<DstPort:A~B> <Proto>
<Frag>
Set the binding tunnel policy.
BindIndex – Indicate the index number (1 ~ 64) for the tunnel to be
bound.
vpn trunk bind set 1 y vpnlb 1
192.168.10.1~192.168.10.2
192.168.99.1~192.168.99.254 1~65535 0 OFF
ACT – Specify the action. “y” means active; “n” means inactive or
delete.
TrunkName - TrunkName - Specify the name of the VPN trunk
created by using “vpn trunk lb” command.
Member – Specify the index number of the LAN to LAN (dial-out)
profile to be bound.
SrcIp:A~B – Specify the source IP range (e.g.,
192.168.10.0~192.168.10.255.
DstI p:A~B - Specify the destination IP range (e.g.,
192.168.1.0~192.168.1.255.
DstPort:A~B – Specify the destination port range (1~65535).
Proto – Specify the protocol.
To Next Page
Loading...
