Draytek Vigor2926L - Page 890

Vigor2926 Series User’s Guide
874
% Dial to : 1.2.3.4
% Remote NEtwork IP : 192.168.1.0
% Remote NEtwork Mask : 255.255.255.0
> vpn setup 2 market pptp_out 5.6.7.8 vigor 5678 192.168.1.31 255.255.255.0
% Profile Change Log ...
% Profile Index : 2
% Profile Name : market
% Username : vigor
% Password : 5678
% Call Direction : Dial-Out
% Type of Server : PPTP
% Dial to : 5.6.7.8
% Remote NEtwork IP : 192.168.1.31
% Remote NEtwork Mask : 255.255.255.0
> vpn trunk lb add comp 1 2
%% Combination VPN Load Balance profile list :
<Index> < Name > < Member1(Active)Type > <
Member2(Act
ive)Type >
1 comp 1(YES)PPTP 2(YES)P
PTP
%% Note: <Active: NO> The LAN-to-LAN Profile is disable or under Dial-In(Call
Di
rection) at present.
====================================================================
% Setting OK.
> vpn trunk bind set 1 y comp 2 192.168.10.1~192.168.10.2
192.168.99.1~192.168.99.254 1~65535 0 OFF
% VPN Load Balance Tunnel Bind Table Index[1] detail:
===========================================================
Action = ACTIVE
Trunk Profile(000) Name= comp
Binding Dial Out Index = 2
Binding Src IP = 192.168.10.1 ~ 192.168.10.2
Binding Dest IP = 192.168.99.1 ~ 192.168.99.254
Binding Dest Port = 1 ~ 65535
Binding Fragmented = NO
Binding Protocol = ANY Protocol
>
T
T
e
e
l
l
n
n
e
e
t
t
C
C
o
o
m
m
m
m
a
a
n
n
d
d
:
:
v
v
p
p
n
n
N
N
e
e
t
t
B
B
i
i
o
o
s
s
This command allows users to enable or disable NetBios for Remote Access User Accounts or
LAN-to-LAN Profile.
S
S
y
y
n
n
t
t
a
a
x
x
vpn NetBios set <H2l/L2l> <index> <Block/Pass>
S
S
y
y
n
n
t
t
a
a
x
x
D
D
e
e
s
s
c
c
r
r
i
i
p
p
t
t
i
i
o
o
n
n
Parameter Description
<H2l/L2l> H2l means Remote Access User Accounts.
L2l means LAN-to-LAN Profile.
Specify which one will be applied by NetBios.
<index> The index number of the profile.
<Block/Pass>
Pass – Have an inquiry for data transmission between the hosts
located on both sides of VPN Tunnel while connecting.
Block – When there is conflict occurred between the hosts on both