DSC Neo - Page 148

Section 6: Programming Worksheets
EN
R 8 – Troubles Inhibits Arming
[021] System Options 9
Description on page 93
For systems compliant with EN50131-1 and EN50131-3, option [021] bit 2 “Keypad blanking while armed” must be
ON.
o 1 – Trouble Display
o 2 – Keypad Blanking While Armed
o 3 – Auto-Arming Bypass
o 4 – Ready Display
o 5 – PGM Keypad Blanking
EN
R 5 – PGM Keypad Blanking
o 6 – Armed Display
o 7 – Open Cancels Arming
EN
R 7 – Open Cancels Arming
o 8 – Audible Exit Delay for Stay Arm
[022] System Options 10
Description on page 94
o 1 – [F] Key Option
o 2 – Not Used
o 3 – Not Used
o 4 – Test Transmission Counter in Hours
o 5 – Away to Stay Toggle
o 6 – 2 Way Full Duration
o 7 – Trouble Beeps Are Silent
o 8 – Keyswitch Arms in Away Mode
EN
R 8 – Keyswitch Arms in Away Mode
[023] System Options 11
Description on page 94
o 1 – Ready LED Flash for Force Arm
o 2 – Not Used
o 3 – Tamper/Fault Detection
o 4 – Access Code Required for [*][1]
EN
R 4 – Access Code Required for [*][1]
o 5 – Access Code Required for [*][2]
EN
R 5 – Access Code Required for [*][2]
o 6 – Access Code Required for [*][3]
- 148 -