7
■ Turning Power ON/OFF
● Turning Power ON
1. Connect the “female plug” of the power supply cord to the
“inlet”.
2. Connect the “male plug” of the power supply cord to the
“outlet”.
3. Press the “I” side on the “power switch”.
The printer is ready when the initial screen appears on the
LCD panel. “Standard Mode” is set for each function.
NOTE: Standard Mode → See page 8.
● Turning Power OFF
1. Press the “O” side on the “power switch”.
The printer is turned off and the panel display goes out.
To Next Page
Loading...
