Duplo DP-J450 - Basic Printing Procedure

17
■ Basic Printing
● Printing Using Basic Functions
1. Press the “I” side on the “power switch”.
NOTE: Turning Power ON/OFF → See page 7.
2. Load paper.
NOTE: Preparing for Printing → See page 12.
3. Load the document.
NOTE: Loading Documents → See page 15.
4. Set the “print tray”.
NOTE: How to Set the Print Tray → See page 14.
5. Make sure that initial screen appears on the LCD panel.
6. Set functions.
7. Press the MASTER MAKING key.
When the master has been made, one test print is
automatically made.
IMPORTANT:
y The test print is for verification purposes only and
may be fainter than the final print.
y You can enter the number of desired prints before
pressing the MASTER MAKING key to
immediately print the required number of copies.
8. Check the printing finish.
0 s h t 1 s e t
 100 %