39
10. Press the PRINT key.
Printing starts again.
11. Repeat the steps 9 and 10.
12. After the print run for the first document has completed,
master making for the second document is performed
automatically and printing starts.
13. Repeat the steps 9 through 11 until the entered sets are
completed.
IMPORTANT:
● The MASTER MAKING key will not work until all
the sets have been printed.
● Press the STOP key and then the CLEAR key
to abort the print run.
REFERENCE:
Using the optional ADF and optional tape cluster, you can
successively perform the master making and collating of
prints of multiple documents.
● Dividing Sections with Tape [Available only with Tape Cluster Unit installed]
Only the specified number of sets is printed with the specified number of prints taken as one set.
Paper tape is inserted when printing of each set is completed. You can enter up to 15 groups
of number of prints x number of sets.
IMPORTANT:
The optional tape cluster is required for dividing sections with tape.
When using this function, refer to the Instruction Manual for the “Tape Cluster”.
To Next Page
Loading...
Need help?
General