38
►How to Enter the Numeric Values for Sequential Batch Print
(Available only with ADF installed)
1. Proceed with steps 1 to 5 of the sequence described in
“Basic Printing”.
Basic Printing → See page 17.
2. Press the key.
The number of prints/sets blinks and the machine enters sequential batch setting mode.
3. Enter the number of prints using the NUMERIC keys.
y If you make a mistake,
start over again by pressing the CLEAR key
and start from the beginning. When you press the
CLEAR key, both the number of prints and the
number of sets are cancelled.
4. Press the key.
The number of prints is set.
5. Enter the number of sets using the NUMERIC keys.
y If you make a mistake,
start over again by pressing the CLEAR key
and start from the beginning. When you press the
CLEAR key, both the number of prints and the
number of sets are cancelled.
6. Press the key.
The number of sets is set.
7. Repeat the steps 3 to 6.
Up to 15 sets can be entered.
8. Press the MASTER MAKING key.
Printing starts from the last-entered print and set quantities,
and stops after the first set of printouts.
IMPORTANT:
Load the document for ‘the last-entered number of prints
and sets’ uppermost and the document for ‘the first-
entered number of prints and sets’ at the bottom.
9. When a set of print is completed, printing stops.
Insert interleaving paper as a mark, or remove the printed
papers.
To Next Page
Loading...
