44
● 2-in-1 Layout (Available only with ADF installed)
Two-in-one (2-in 1) mode allows you to print two small documents on one page and also easily
print for creating booklets that will be saddle stitched.
When you use 2-in-1 mode, the layout is as follows:
IMPORTANT:
● Select “2-in-1 Layout” before starting master making.
● You cannot use 2-in-1 mode unless the optional ADF is installed.
● Always load the documents in the ADF.
● If you are printing the documents at 100%, select a printing paper that is the size of
the two documents.
● When you enlarge or reduce two documents size by side, select a zoom ratio so that
the documents fit exactly on one page.
● Note the following when using 2-in-1 layout mode:
* You must load the document in the ADF in portrait orientation.
* You must select a master size and zoom ratio that will accommodate two
documents.
* Correct layout may not be obtainable with other than standard size papers.
Document Printout 1 Printout 2
(even number)
B A D C
3
4
1
2
3
41
2
Document Printout 1 Printout 2 Printout 3
(odd number)
B A D C E
1
2
3
4
51
2
3
4
5
To Next Page
Loading...
Need help?
General