Duplo DSC-10/60i - Chapter 2: Operations; Operation Procedure Overview

2-1
Chapter 2 Operations
Chapter 2 Operations
1. Operation Procedures
(1*): Refer to the operation manual of the PC CONTROLLER.
(2*): When you set interleaf 1 or interleaf 2.
(p.2-2)
Power On
(p.2-2)
Adjusting the position of the
sub-guide
(p.2-3)
Adjusting the position of the
reject tray stopper
(p.2-3)
Adjusting the height of the
level sensor
(p.2-4)
Adjusting the separating air
(p.2-4)
Adjusting the height of the
separator
(p.2-5)
Adjusting the strength of
separating air
(p.2-5)
Adjusting the suction box
shutter bar
(p.2-6)
Load paper on the paper feed
tray
(p.2-11)
Set the paper guide
Set at PC CONTROLLER (*1)
(p.2-22)
Checking the paper feeding(Collate
one set of paper using the preset
key)
(p.2-23)
Start/Stop of collation
• Set paper ejection direction
• Set block mode
• Set processing mode
• Set inter leaf mode (2*)
• Set double feed detection
level
• Set suction amount
• Set clutch feed timing
• Input No. of sets to be
processed