2-14
Chapter 2 Operations
5. PC CONTROLLER
In this machine, the following items are set by the PC CONTROLLER.
For operations of the PC CONTROLLER, refer to the operation manual of the PC CONTROLLER.
5-1. Making Basic Setting
• Towers used
• Paper Ejection Direction
• Block Mode , Block Change
• Processing Mode
• No. of Sets for Interleaf
5-2. Making Detailed Settings
• Overlap Amount
• No. of Tray Error To Stop Machine
• Conveyance Jam Detection
5-3. Setting the Paper Feed Tray
• Double Feed Detection Level
• Double Feed Detection
• Feed Error Detection
• Suction Amount
• Tray Lowering Amount
• Clutch Feed Timing
• Feed Start Timing
5-4. Setting the LUL-HM
• Preset Ejection Place
• Hand Marry
• Hand Marry Timing
To Next Page
Loading...
