4-1
Chapter 4 Cleaning the Machine
Chapter 4 Cleaning the Machine
1. Cleaning Parts
•
Before cleaning, be sure to turn OFF the power.
•
Clean the conveyance belts and conveyance rollers once a day.
Problems may result if they are dirty.
•
To clean, moisten a cloth with water or alcohol, and wipe the dirty part.
•
If using the machine after cleaning, wait for the parts cleaned to dry completely rst.
1-1. Cleaning the Suction Belt
Suction belt
Conveyance shaft
Clean the suction belt while rotating
the conveyance shaft by hand.
The suction belt unit will be removed by
pressing the joint section of the conveyance
shaft.
Insert the joint section securely to install
the conveyance shaft. Check that the
suction belt rotates smoothly after
installation.
1-2. Cleaning the Vertical Conveyance Belt
Clean while rotating the vertical
conveyance belt by hand.