2-23
Chapter 2 Operations
When mis-detection occurs
Double-feed or miss-feed may sometimes be detected although the paper is fed normally.
• If mis-detection of double-feed occurs with the double-feed detection function set to thin paper, set it
to thick paper and perform preset again.
If double-feed occurs even when set to thick paper, it means that the double-feed detection function
cannot be used for the paper.
Turn OFF the double-feed detection function and perform pre settings again.
• If mis-detection of miss-feed occurs with the double-feed detection function set to thick paper, set it
to thin paper and perform preset again.
If double-feed occurs even when set to thin paper, it means that the double-feed detection function
cannot be used for the paper.
Turn OFF the double-feed detection function and perform pre settings again.
9-2. Start/Stop of Collation
1
Press key for about one second.
Collation of paper will start.
When connecting more than two towers,
if the leftmost tower is set so that collated
paper is ejected to the left side and the
rightmost tower is set so that collated
paper is ejected to the right side, collation
operations of these two towers cannot be
carried out simultaneously.
2
Press key.
Collation of paper will stop.
To Next Page
Loading...
