2-24
Chapter 2 Operations
10. Waiting Mode
The waiting mode is used to standby keeping the paper feeding conditions without stopping the machine,
when a problem has occurred or under certain conditions.
10-1. When the Waiting Mode is Activated
The waiting mode is activated dierently according to the setting details of PC CONTROLLER.
For further details, refer to the instruction manual of PC CONTROLLER.
• When the waiting mode is activated, the operation lamp changes from lighting up to blinking.
• While the waiting mode is selected, the lamp continues to blink. It will change from blinking to
lighting up by restarting operation.
• If the state of waiting mode continues to remain for three minutes, the machine will stop
automatically. If the machine stops operation completely, the operation lamp will change from
blinking to lighting o.
A B
A: Double-feed lamp
B: Paper feed error lamp
Control Panel
1. Double-feed or mis-feed has occurred.
The feed error lamp lights up, and the lamp
lights up on paper feed tray where paper is
double-fed or mis-fed.
2. key was pressed while paper
was being conveyed.
Press key to tentatively stop paper feed
operation only.
To Next Page
Loading...
Need help?
General