EasyManuals Logo

DURAG D-ISC 100 P 2 User Manual

DURAG D-ISC 100 P 2
212 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
4 | Installation and commissioning
36
D-ISC 100 x xx2
Analogue and digital output
connection
The analogue and digital output is connected via terminal X3 on
the CPU module of the D‑ISC100. The function of the digital out-
puts can be switched between NC (normally closed) and NO
(normally open) using the switches SW1 and SW2.
Fig.4.3: Wiring digram for the analogue and digital output
The plug assignment for X3 can be found in the following table.
Plug
position
Description
X3
X3.1 AO 0.1 AO+, evaluation system+
X3.2 AO-, evaluation system-
X3.3 DO 0.1 Nx digital output
(Nx≙SW1)
X3.4 CO digital output
(common)
X3.5 DO 0.2 Nx digital output
(Nx≙SW2)
X3.6 CO digital output
(common)
SW1…2 NO/NC switch-over for DO0.1…2 switch
position shown corresponds to NO
Table4.1: Switch and plug assignment for the analogue and digital output
4.2.4 Bus connection
D‑ISC100 bus connection
(conventional)
Bus cables can be connected directly at the terminals of the
D‑ISC100 CPU module or using M12 connectors. Additional in-
formation on this is provided in this section.
The wiring of the individual components in a DURAG sensor sys-
tem is described in the following sections.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DURAG D-ISC 100 P 2 and is the answer not in the manual?

DURAG D-ISC 100 P 2 Specifications

General IconGeneral
BrandDURAG
ModelD-ISC 100 P 2
CategoryControl Unit
LanguageEnglish

Related product manuals