Need help?Do you have a question about the DURAG D-ISC 100 2 Series and is the answer not in the manual?
General| Type | Control Unit |
|---|---|
| Model | D-ISC 100 2 Series |
| Manufacturer | DURAG |
| Input Voltage | 24 V DC |
| Operating Temperature | -20 °C to +50 °C |
| Relative Humidity | Max. 95 % RH, non-condensing |
| Weight | Approx. 1.5 kg |
| Communication Interface | RS485 |
| Certifications | CE |
Covers general guidelines for installation, operation, maintenance, and dismantling by qualified personnel.
Details hazards related to electric current and electrostatic discharge (ESD).
Specifies the intended application of the D-ISC 100 and its unsuitability for certain environments.
Details standard installation procedures for D-ISC 100 P, M, C, and R models.
Explains how to plan and make electrical connections, including notes on data cables and bus termination.
Outlines the necessary settings like time, sensors, and outputs for initial setup.
Defines which measurements, sensors, and display formats are shown on screen.
Covers Modbus communication parameters, baud rate, parity, and bus termination settings.
Allows adding, removing, parameterizing, and retrieving information about connected sensors.
Highlights electrical hazards and precautions required before performing any maintenance work.
Describes cleaning procedures, checking seals, and general care of the D-ISC 100 housing.
To Next Page
