DURAG D-ISC 100 2 Series User Manual

12 | Messages/error elimination
D-ISC 100 x xx2
137
12 Messages/error elimination
12.1 System message categories
Messages output by the system are divided into 4 categories:
Information:
[
Information]
The messages in this group have a purely informative character
(e.g. "Startup").
No LED signal is displayed when messages in this category are
present.
Warnings:
[
Warnings]
Messages of this category necessitate the attention of the oper-
ator (for instance maintenance requirements, time not set,
change of battery necessary). But a system fault is not (yet) ex-
pected.
An LED signal accompanies messages in this category.
Simple error:
[
Simple error]
Messages due to a simple system fault (e.g. incorrect configura-
tion / assembly) belong to this category.
"Simple errors" can generally be rectified on-site by a qualified
technician.
A red LED signal accompanies messages in this category.
Critical error:
[
Critical error]
This category contains messages issued due to a serious system
fault (e.g. hardware error).
"Critical errors" generally need to be rectified by qualified special-
ised personnel using special tools. On-site repair is often im-
possible.
A red LED signal accompanies messages in this category.
See also Section 12 Messages/error elimination [}137].
12.2 Information
Note:
The English language version of the software display is indicated
in square brackets in each case.
Code Message Measures
[001] [Startup (power on)] -
[002] [Startup (external reset)] -
[003] [Startup (watchdog reset)] 1. If a soft reset is desired, no further measures are
necessary.
2. In the event of multiple, unwanted resets, contact
DURAG Service.
[004] [Startup (bod reset)] In the event of multiple occurrences contact
DURAG Service.

DURAG D-ISC 100 2 Series Specifications

General

Brand	DURAG
Model	D-ISC 100 2 Series
Category	Control Unit
Language	English