DURAG D-ISC 100 2 Series User Manual

10 | Channel setup menu 4
D-ISC 100 x xx2
113
● With activated software module "MC0: Media conditions", the
media pressure is distributed from D−ISC100 to all connec-
ted sensors.
Standard temperature [°C]
● Temperature used for standardisation
● If the standardised temperature value differs from 0°C, this
can be set here.
● Default value = 0°C
Standard density [kg/m³]
● Standard density of the measuring medium.
● For example, this is required to calculate the mass flow.
10.3.5.4 [Maintenance setup]
Reference check set value:
Reference check set value
Press the
key to change…
● Value in % to which the sensor's internal reference point
measurement is scaled in order to output the value in the set
signal range.
● Adjustment range 5…95%
Control cycle step duration:
Control cycle step duration
Press the
key to change…
● Setting the duration of each individual step of the check cycle
in seconds.
Check cycle interval:
Control cycle interval
Press the
key to change…
● Setting the interval of the automatic check cycle in hours.
● 0 = automatic check cycle is disabled.
Fault indication rejection:
Fault indication rejection
Press the
key to change…
● If a failure is detected by the system, this results in a pro-
grammed response. The system also saves the appropriate
(error) message. The message is saved in the memory of the
message logbook (in the sensor) and can provide the main-
tenance technician with information for/when carrying out
device maintenance, if applicable.
● Error message suppression designates the time period (in
seconds) for the sensor's initial pause. The system response
is then only initiated if the fault still persists after the specified
time has expired. This means transient failures can be ig-
nored without triggering a system response.
Time to next control cycle
[h:mm:ss]:
Time to next control cycle [h:mm:ss]
(read only)
● Indication of remaining time to next control cycle.
● Display -:--:--= automatic check cycle is disabled.
Reset control cycle timer:
Reset control cycle timer
Carry out (!) with the
key.

DURAG D-ISC 100 2 Series Specifications

General

Brand	DURAG
Model	D-ISC 100 2 Series
Category	Control Unit
Language	English