DURAG D-ISC 100 2 Series User Manual

10 | Channel setup menu 4
108
D-ISC 100 x xx2
● Selecting the desired analogue output and pressing the
key
assigns the new sensor channel. This overwrites any existing
assignment.
● A sensor channel can also be assigned to multiple analogue
outputs. To do so, repeat the above step.
After finishing the assignments, the list can be exited by pressing
the
key.
Signal range of
analogue output (AO):
[
Signal range of analogue output (AO)]
● Quick access to the "Signal range" menu in the specific para-
meters of the respective analogue output (see example:
"15.10.1 Setting the signal range [}177]").
● Quick access is not possible if the sensor channel has not be
assigned to any analogue outputs or has been assigned to
multiple outputs. A corresponding message is displayed.
Assign measurement unit:
[
Assign measurement unit]
● This allows the sensor channel to be assigned to a measured
variable/measurement unit.
● Selecting this menu item displays a list of all measured vari-
ables/measurement units that are supported by the respective
sensor.
● The selection bar always indicates the measured variable that
is currently set.
● The arrow keys (
) can be used to select a new variable.
Press the
key to select.
● If the sensor channel is not used/not to be used, the selection
is set to "not assigned"
● The sensor channel now supplies measured values in the se-
lected measurement unit.
10.3.4 [Functions] (sensor)
● The available functions depend on the selected sensor.
● The functions can be used to start and stop certain sensor ac-
tions (see "Example" below).
● A function is activated by selecting and confirming with the
key.
-> Automatic reporting sequence:
“[
Requested]" -> "[ accepted"]
● These messages
only refer to the function's execution status,
not to the action itself.
Example:
● The sensor is to be set to the "Maintenance" status:
1.
In the "Maintenance functions" menu, select the "Set mainten-
ance" function.
2.
The "Set maintenance" function is now started by pressing
the
key. The maintenance status can be checked in the
status of the measuring device -> "Maintenance/Check func-
tion (C)" is active.

DURAG D-ISC 100 2 Series Specifications

General

Brand	DURAG
Model	D-ISC 100 2 Series
Category	Control Unit
Language	English