DURAG D-ISC 100 P 2 User Manual

9 | System setup menu 3
92
D-ISC 100 x xx2
9.4 [Backup/Restore]
D−ISC100C, M, P, R
Table9.1: Supplied SD card in the device
For work described in this section, the
supplied memory card
must be inserted into the Universal control unit.
This SD card is an industrial version which differs from the stand-
ard card in certain respects, such as an extended specification
for the temperature range.
On delivery, the SD card is inserted into the slot on the
D‑ISC100 Universal control unit. It can be withdrawn briefly to
allow the data to be saved or viewed
additionally on the PC.
The settings of the D‑ISC100 basic system can be saved to the
SD card or can be read from it.
Settings for the connected sensors and expansion modules
can-
not
be saved. These settings are saved in the respective sensor/
module. These settings can be saved using the D-ESI 100
[}203].
Menu: 3.4.1
Backup / Restore
\\System setup\Backup / Restore
Backup system settings
Restore system settings
Status: S1.3:Normal measurement
E
Restore factory settings
Fig.9.7: Backup/Restore selection menu
The
"Backup/Restore" menu item is divided up as follows:
●
Backup system settings]
●
Restore system settings]
●
Restore factory settings]
9.4.1 [Backup system settings]
Calling up this menu item automatically saves the settings of the
D‑ISC100 basic system to the SD card. The backup is per-
formed immediately, without a further questions or confirmations.

DURAG D-ISC 100 P 2 Specifications

General

Brand	DURAG
Model	D-ISC 100 P 2
Category	Control Unit
Language	English