DURAG D-ISC 100 P 2 User Manual

10 | Channel setup menu 4
116
D-ISC 100 x xx2
10.4.1.1 [Active modules]
● List of software modules that are activated on this D‑ISC100
and that can be used.
● A module must be enabled before use (see Section 10.4.1.3
Enable/disable modules [}116]).
10.4.1.2 [Activate modules]
Fig.10.23: Software certificate
● Enter an activation key to activate a software module that has
been purchased as an additional option (menu 3.3.1.2).
● The activation key can be found on the software certificate
and is only valid for the D‑ISC100 with the "Mainboard ID" in-
dicated on the certificate.
● If the entered activation key is valid, a message will be dis-
played indicating the progress of the activation, with sub-
sequent information on which module has been activated.
The detailed procedure for activating a software module can be
found in Section 15.13 Example: Activate modules [}190].
10.4.1.3 Enable/disable modules
● A list of all active modules with the option of enabling or dis-
abling.
● If the module is disabled, it does not appear in the module list
and it is also not displayed in the measurement and status
display.
● If a disabled module (empty status indicator
) is to be en-
abled, it must be selected in the list and enabled using the
arrow key (full status indicator ).
● A module can be disabled in the same manner using the
ar-
row key (empty status indicator).
● The changes made are executed when leaving the menu.
10.4.1.4 [Mixed channel] (MX1...2)
Possible sources of a mixed channel[ are] sensors (S), ex-
ternal sensors (SX) and media conditions (MC).
The source assignment takes place in the respective channel
menu of the software module (MX1/MX2) e.g. 4.3.MX1.1 for
MX1. This menu lists the 4 channels of the MX module with the
current assignment.
Selecting one of the channels (
key) allows its source assign-
ment to be established/changed or even removed (e.g.
4.3.MX1.1.1.1 "Remove assignment").
For source assignment, the desired sensor or module is firstly
selected from the list (e.g. 4.3.MX1.1.1.S1 for sensor S1), fol-
lowed by the selection of the measurement channel (e.g.
4.3.MX1.1.1.S1.1 for sensor S1.1).

DURAG D-ISC 100 P 2 Specifications

General

Brand	DURAG
Model	D-ISC 100 P 2
Category	Control Unit
Language	English