DURAG D-ISC 100 P 2 User Manual

8 | Display setup menu 2
88
D-ISC 100 x xx2
●
[Type and option]
Select the measurement display format.
8.3.1 [Use current display setting]
Menu: 2.2.1
Measurement display after syst
Use current display setting
Device
Type and option
E
Fig.8.5: Select the display after system start
● [
"Use current display setting"] transfers the
[
current measurement display] into the settings for the [
"Measurement display after system start"].
The current measurement settings are written to the perman-
ent memory, i.e. they will continue to be used even following
a reset or restart.
Measurement display after
System start equals current
OK
Fig.8.6: Confirmation prompt
Please note:
When the current display settings are transferred to
the "Measurement display after system start", the previously
used measurement display will be overwritten after system start.
It is not possible to restore the settings. There is therefore a con-
firmation prompt before the settings are transferred (see figure
on the left). Pressing the
key (keypad) prevents transfer.
8.3.2 [Device]
● Select the measuring devices for which the measured value/
status display(s) are to be shown.
From the selection made here, the left/right arrow keys (
)
can be used to call up the required displays in the measure-
ment display (see also Fig.8.3).
8.3.3 [Type and option]
see 8.2.1 Type and option [}87]
8.4 [Contrast]
Menu: 2.3
Status: S1.1:Normal measurement
Contrast [%] : 90
Display contrast value in %
E
Fig.8.7: Setting the contrast
● Setting the display contrast to correspond to the operator's
needs (0..100%, low...high)

DURAG D-ISC 100 P 2 Specifications

General

Brand	DURAG
Model	D-ISC 100 P 2
Category	Control Unit
Language	English