Dynapac F 161 W - Page 191

F 8.2 3
F_8.2_01_GB.fm 3-20
No.
Interval
Points of maintenance Remark
10 50
100 250
1000 5000
20000
as required
2
q
- Generator
Operational checking of the
insulation supervision of electrical
equipment
Also see
the opera-
tion man-
ual of the
screed
q
- Generator
Visual checking for pollution or
damage
- Check the cooling air openings
for pollution or clogging, clean as
required.
(o)
q
- Generator
Check the ball bearings „by
listening“ and replace them as
required.
(o)
qq
- Generator
Replacement of ball bearings
(o)
q
- Generator
Check the drive belts (o) for
injury and replace them as
required.
(o)
q
- Generator
Drive belts (o) - check tightness
and adjust as required.
(o)
Only on
version with
V-belt!
q
- Generator
Replacement of drive belts (o)
(o)
Maintenance q
Maintenance during run-in period g