MGR10 A/B/C - Revision : I (for 7.0 software revision) 20
The [Quit] and [OK] menu options consistently use the following keys.
Use the [Quit] key to leave a menu or return to the Resistance Measurement mode screen. Use the
[OK] key to confirm a particular choice and continue to the next set of menu options.
Not all function keys are used to access the Configuration Mode. Some just invoke the function
which is printed on the key. For example pressing
immediately sets the measured value displayed to zero.
The rest of this section describes each key in detail and gives examples of how to configure the
measurement to your requirements.
The last used set up conditions are stored when the instrument is turned off and restored upon
switch on.
Quit
3k
OK
30k
5
ZERO
ZERO
To Next Page
Loading...
Need help?
General
