191
Appendix A—Description of parameters
POWERXL DH1 SERIES ADJUSTABLE FREQUENCY DRIVES MN040041EN—August 2019 www.eaton.com
Code Modbus ID Parameter Application RO/RW
P10.2.4 2478 Redundant Run Time Reset 2,3 RW
Use this parameter to manually Reset the Redundant Drive Run timer.
P10.2.5 2479 Redundant RunTime Limit 2,3 RW
Use this parameter to set the time limit for Run time of the drive when enabled for the Redundant
drive scheme.
P11.1.1 2487 Interval 1 Setting 2,3 RW
Use this parameter with the Interval time setting for interval 1 to set the desired time frame for the
selection; to be Weekly or Daily.
0 - Weekly - would setup the timer for the week long. Drive starts on the on day/time and runs to the stop
day and time.
1 - Daily - would setup the timer for the defined day. Drive starts on time and stops on that day off time, for
the listed days in the sequence
P11.1.2 491 Interval 1 On Time 2,3 RW
Use this parameter to set the on time for Interval function. It uses 24-hour format. Use to specify a time of
day for a desired function to be disabled.
P11.1.3 493 Interval 1 Off Time 2,3 RW
Use this parameter to set the off time for Interval function. It uses 24-hour format. Use to specify a time of
day for a desired function to be disabled.
P11.1.4 517 Interval 1 From Day 2,3 RW
Use this parameter to set the day of week for Interval function to start on.
0 = Sunday
1 = Monday
2 = Tuesday
3 = Wednesday
4 = Thursday
5 = Friday
6 = Saturday
P11.1.5 518 Interval 1 To Day 2,3 RW
Use this parameter to set the day of week for Interval function to stop on.
0 = Sunday
1 = Monday
2 = Tuesday
3 = Wednesday
4 = Thursday
5 = Friday
6 = Saturday
P11.1.6 519 Interval 1 Channel 2,3 RW
Use this parameter to assign the interval to a select time channel to store the interval time.
0 = Not used
1 = Time channel 1
2 = Time channel 2
3 = Time channel 3
P11.2.1 2488 Interval 2 Setting 2,3 RW
Use this parameter with the Interval time setting for interval 2 to set the desired time frame for the
selection; to be Weekly or Daily.
0 - Weekly - would setup the timer for the week long. Drive starts on the on day/time and runs to the stop
day and time.
1 - Daily - would setup the timer for the defined day. Drive starts on time and stops on that day off time, for
the listed days in the sequence
P11.2.2 495 Interval 2 On Time 2,3 RW
Use this parameter to set the on time for Interval function. It uses 24-hour format. Use to specify a time of
day for a desired function to be disabled.
P11.2.3 497 Interval 2 Off Time 2,3 RW
Use this parameter to set the off time for Interval function. It uses 24-hour format. Use to specify a time of
day for a desired function to be disabled.
To Next Page
Loading...
