XS series operating manual
XS user manual v0.55 - 141 -
15 Measurement I/O on the rear panel
With the options ( RXS et DXS) and XS-05-01(SXS), the measurement connections are
situated on the rear panel.There are no changes concerning the hipot tests and the
insulation measurements.
The inputs and outputs of the ground continuity are passed to a female receptacle rapid
Jaeger.
The wires connected to IA et IB must be a 4 mm
2
section cables. The wires
connected to UA and UB could be a section cable between 1mm
2
to 4mm
2
.
To Next Page
Loading...
Need help?
General
