XS series operating manual
XS user manual v0.55 - 84 -
Fig 10.9
How to run a simple sequence
From the measurement screen, press on [MEASUREMENT] button
WARNING,
Never touch the specimen under test when it is connected to the unit and the red lamp is ON.
The tests are performed automatically and each result is displayed at the test end on the
corresponding program line.
At the end of the complete sequence the END OF TEST message is displayed.
All the test result steps are accessible on the LCD screen. Use the UP and DOWN arrow keys to
scroll the results and the pages.
Fig 10.10
Press on DISCHARGE button to clear the screen and escape the sequence mode with ESC key.
WARNING
Pressing on DISCHARGE button clears the screen and therefore the test results.
To Next Page
Loading...