44
Basic operation
Adjusting sound quality
The sub-woofer output can be set to STEREO or MONO. Select the method that matches the
output method for the connected sub-woofer system.
Touch or for
WOOFER OUTPUT.
● Touch after making
settings. The woofer output setting will
be saved and the system will return to
the previous screen.
The frequencies for the front and rear speaker high-pass filter (HPF) and sub-woofer low-pass
filter (LPF) can be set within a range of 63 to 200 Hz. (This is the same as setting the HPF and
LPF cutoff frequencies.)
Touch or to select the cut
off frequency.
Touch , or
to select the slope.
● Touch after making
settings. The crossover setting will be
saved and the system will return to the
previous screen.
Setting WOOFER OUTPUT
STEREO MONO
BACK
Setting crossover
6dB/oct 12dB/oct
PASS
BACK
If no sub-woofer has been connected, set the slope adjustment to “PASS”. (If slope
is set to a setting other than PASS, the low frequency range will not be output from
the speakers.)
To Next Page
Loading...
Need help?
General
