EDAN F9 - 4.7 Choosing Signal Loss Delay; 4.8 Pausing or Resetting the Alarm; 4.9 Switching Transducer Unplugged On or Off; 4.10 *Reviewing Alarms

F9 Fetal & maternal Monitor Service Manual Disassembling the Monitor
- 60 -
5)
Remove seven screws on the back of display assembly and the two roll shaft covers.
6)
Pull out the wires then open the display assembly with care.
7)
Remove the touch screen signal cable from the LCD.
8)
Remove the six screws securing the LCD to the case.
Display Assembly Stander
Roll Shaft Covers