C
HAPTER
1
| Introduction
System Defaults
– 21 –
SYSTEM DEFAULTS
The following table lists some of the basic system defaults.
Table 2: System Defaults
Function Parameter Default
Authentication User Name admin
Password admin
802.1X Port Authentication Disabled
Port Security Disabled
IP Filtering Disabled
Web Management HTTP Server Enabled
HTTP Port Number 80
SNMP SNMP Agent Disabled
Community Strings “public” (read only)
“private” (read/write)
Port Configuration Admin Status Enabled
Auto-negotiation Enabled
Flow Control Disabled
Rate Limiting Input and output limits Disabled
Port Trunking Static Trunks None
LACP (all ports) Disabled
Storm Protection Status Broadcast: disabled
Multicast: disabled
Unknown unicast: disabled
Spanning Tree Algorithm Status Enabled, RSTP
(Defaults: RSTP standard)
Edge Port Enabled
Virtual LANs Default VLAN 1
PVID 1
Traffic Prioritization Ingress Port Priority 0
Queue Mode Weighted Fair Queuing
Weighted Fair Queuing Queue: 1 2 3 4 5 6 7 8
Weight: 1 2 3 4 5 6 7 8
IP DSCP Priority Disabled
IP Settings IP Address 192.168.1.1
Subnet Mask 255.255.255.0
Default Gateway 0.0.0.0
DHCP Client: Disabled
Multicast Filtering IGMP Snooping Snooping: Disabled
Querier: Disabled
To Next Page
Loading...
Need help?
General