Edge-Core ECS4310-26T - IGMP VLAN Setting; Figure 20: IGMP Snooping Global Settings

C HAPTER 9 | IGMP Snooping
IGMP Snooping Setting
– 69 –
Figure 20: IGMP Snooping Global Settings
IGMP VLAN SETTING The following parameters are displayed for the VLAN Setting section of the
IGMP Snooping Setting page:
◆ VLAN ID — Specifies the ID of a configured VLAN on the switch.
(Range: 1-4094)
◆ VLAN Name — Displays the name of the VLAN.
◆ Snooping State — Enables IGMP snooping on the VLAN.
(Default: Disabled)
◆ Querier State — Enables IGMP querier on the VLAN.
(Default: Disabled)
WEB INTERFACE
To configure IGMP Snooping settings:
1. Click Configuration, IGMP Snooping, IGMP Snooping Setting.
2. Specify the VLAN ID.
3. Enable IGMP Snooping on the VLAN.
4. Enable IGMP Querier on the VLAN if you want this switch to be elected
as querier.
5. Click Apply.