Introduction
EST2 System Operations Manual 1.5
Installation and operation procedures
The typical procedure will appear in the following format:
To activate an action:
1. At the 2-LCD, press Activate.
2. Enter a level 1, 2, or 3 password.
3. Press 2 to select Action.
4. Enter the number of the action being activated (nnnn).
The word “Enter,” in steps 2 and 4 implies that the operator will
press the appropriate numbers and the ENTER key on the 2-LCD
keypad. See Operating panel devices for more information.
To Next Page
Loading...
